St. George, UT · Drywall

Drywall Hang, Tape, and Texture on a Garage Storage Room

A framed storage room inside a St. George garage got its walls: drywall hung inside and out, seams taped and mudded across multiple visits so each coat could dry, then spray texture to match a finished interior look. Floors and the surrounding garage stayed protected the whole way.

Completed: Completed November 2025
Location: St. George, UT · Washington County
Service: Drywall Hanging, Taping & Texture
Property type: Residential

Documented Visits

November 14 to 25, 2025

Spray Texture

Finish

Interior and exterior faces plus ceiling

St. George

Location

Washington County, Utah

What the customer called us about

A new storage room had been framed into the corner of the garage, but framing alone is not a room. It needed drywall hung on both faces, the seams finished, and a texture that would let it read as part of the house instead of a plywood box.

The garage was in daily use, so the work had to happen without turning the whole space into a construction zone.

What Viking did

Hung drywall on the interior and exterior faces of the framed storage room, with cutouts for the electrical boxes
Taped every seam and corner, then built up mud coats across separate visits so each coat could dry properly between passes
Finished the room's interior walls and ceiling, not just the faces visible from the garage
Masked the surrounding garage with protective film and paper before spraying
Applied spray texture to blend the new walls with a standard interior finish
Protected the garage floor with taped-down builder paper for the duration of the work

Photographs from the job

Original photos taken by Viking Solutions on site in St. George.

Before

New drywall hung on a framed storage room inside a St. George garage with floor protection paper taped down — Board hung on the framed room, floor already papered. This is where the finishing work starts.

During the work

Drywall seams taped and first mud coat applied on a garage storage room, screw heads spotted — Same day, first pass: seams taped, screws spotted. Then it has to dry.

Interior of the storage room with mud coats built up on walls and ceiling and a ceiling light fixture overhead — Inside the room ten days later: coats built up on the walls and ceiling.

Drywall finishing cannot be rushed past its dry times

The photo dates on this job tell the honest story of drywall work: board hung and first coats on November 14, later coats on November 24, texture on November 25. Mud has to dry before the next coat goes over it, and a finisher who stacks wet coats to save trips leaves you with cracks and shrink lines a few months later.

The other discipline on this job was containment. Spray texture goes everywhere it is allowed to. The door and surrounding garage were masked off with film, and the floor stayed papered from the first day, so a finished room did not come at the cost of a repainted garage.

Materials and products used

Drywall sheets

Hung on both faces of the framed room, with electrical box cutouts

Joint tape and compound

Built up in coats across separate visits, sanded between passes

Spray texture

Applied over masked surroundings to match a standard interior wall finish

Floor and masking protection

Builder paper taped to the slab plus film masking before texture

The result

The framed corner of the garage is now a real room: finished walls inside and out, a finished ceiling, and texture ready for paint.

The rest of the garage came through clean because it was protected before the messy stages started, not after.

Worth knowing

When a drywall bid seems slow because it spans several visits, that is usually the honest bid. Coats that dry properly are what keep the seams invisible a year later.

Questions about this kind of work

Why does a drywall job take more than one visit?

Because joint compound has to dry between coats. This room was taped and coated on the first visit, built up on a later visit, and textured on the final one. Stacking wet coats in a single day is faster and produces seams that crack and shadow within months.

Can you drywall a room someone else framed?

Yes. On this job the storage room was already framed inside the garage, and Viking handled everything from bare studs to textured walls: hanging, taping, mudding, and spray texture on both faces plus the ceiling.

How do you keep drywall dust and texture off everything else in the garage?

Protection goes down before the mess exists. The floor was covered with taped builder paper from day one, and before texture was sprayed the surrounding garage and door were masked with film. Texture overspray is nearly impossible to remove from bare concrete, so prevention is the whole strategy.